WinCtrl RMP
The WinCtrl RMP provides several output devices in MobiFlight for use when creating profiles.
Configuring active and standby value display
Four outputs are provided to control the active and standby displays:
Active Value: The current value for the ACTIVE (left) display.Standby Value: The current value for the STBY/CRS (right) display.Active Mode: Determines how theActive Valueoutput is displayed.Standby Mode: Determines how theStandby Valueoutput is displayed.
The supported values for Active Mode and Standby Mode are:
| Mode | Use | Unit | Simulator value -> Displayed value |
|---|---|---|---|
| 0 | Blank display | not applicable | blank |
| 1 | VHF/HF COM, VOR, and ILS frequencies | MHz | 118.005 -> 118.005, 113.3 -> 113.300 |
| 2 | ADF/NDB frequencies | KHz | 347 -> 347.0, 1750 -> 1750.0 |
| 3 | Course (CRS) | degrees | 240 -> C-240 |
| 4 | VHF3 DATA | not applicable | -> dAtA |
The value must be output in the appropriate unit for the display based on the set mode. The panel will format the value, but will not do unit conversions.
Changing the Active Mode or Standby Mode value immediately discards the stored Active Value or Standby Value. Setting the mode to 0 or 4 takes effect immediately. Setting the mode one of the other options will leave the display unchanged until a new value is provided.
Controlling display brightness and test mode
The following outputs configure the brightness for the RMP displays:
Backlight PercentageLCD percentage
Test mode for the LCD is controlled by the LCD Test On/Off output.
Controlling indicator LEDs
The following outputs control the device indicator LEDs:
SELVHF1VHF2VHF3LOADHF1HF2AMNAVVOR/ILSGLSADF